R&G Speedo Protection Film Kit - Scratch Resistant Material

The classic instrument panel on the motorcycle is increasingly being replaced by modern displays. The most important information is immediately available at a glance and the good readability also speaks for itself. With a high-quality display protection film, you can effectively protect thespeedometer unit on your motorcycle from negative influences. This contributes to the value retention of the entire vehicle and increases the resale value.

Rough damage, such as that caused by stone chips or keys, is a thing of the past. In the TecBike Online Shop you can get speedometer protection films from R&G Racing for the following motorcycle brands, among others:

• Aprilia
• BMW
• Ducati
• Honda
• Kawasaki

Please note: The mentioned brands are only a part of our total assortment.

Speedo protection film for your motorcycle - this is how it works

The application of the speedometer protection film on your motorcycle is easy. In our TecBike Online Shop you can already get practicalcomplete sets. The sets contain cut to fit your motorcycle:

• R&G Second Skin Dashboard Protection Kits
• Mini spray bottle
• Polishing cloth (suede)
• Wet and dry wipe
• Squeegee and dust removal strip

The application of a speedometer protection film in 5 steps

Step 1

First, add a drop of dishwashing liquid along with some water to the small spray bottle and mix well.

Step 2

Now it's time to work on the motorcycle. Take the wet wipe out of its package. Carefully and thoroughly clean the display, even if it looks clean. You'll be surprised how much dirt is removed.

Then dry the cleaned surface of the display with the dry wipe. You can use the dust removal strip to pick up the last bits of dust and dirt. The speedometer is now ready for the protective film.

Step 3

For this step, wet the display surface with the liquid from the mini spray bottle. Make sure that the main adhesive surface is covered with a thin film of water.

Now take the speedometer protection film. The side that goes on the display is clearly marked. Carefully remove the protective film from this side. It is essential not to touch the adhesive surface.

Use the spray bottle to spray the water-rinsing mixture onto the surface and place it on the display surface. The liquid makes it possible to optimally align the speedometer protection film.

Step 4

Using the plastic squeegee, spread the excess liquid together with air bubbles from under the speedometer protection film from the inside to the outside.

Step 5

The top side of the speedometer protection film for your motorcycle is also covered by a protective film. Pull it off carefully. To prevent the protective film from coming off the speedometer, hold it at one corner.

If it has come off, that is not a problem. Take the plastic squeegee and the suede polishing cloth again. Wrap the polishing cloth around the narrow edge of the squeegee to prevent scratches on the film. Now you stroke out all air bubbles etc. again. If there are still some small air bubbles under the display protection film, they will disappear by themselves within the next 24 to 48 hours.